Premium grade anti-slip tape providing a high-traction surface for steps, ramps & walkways
- do it once and do it right
For the 'best value' solution, choose high quality TALON™ tapes & follow our installation guidance below
Anti-Slip Tapes and Treads should be applied to clean, dry and relatively smooth surfaces. Dusty, soiled and porous surfaces should be thoroughly cleaned and prepared with anti-slip floor primer to ensure the best adhesion and ultimately product longevity. Edge sealer is also recommended for best results to prevent water / chemical ingress.
Application is best carried out when the ambient temperature is above 10oC. We recommend the use of a seam roller to apply even pressure to achieve the required 'tack' / initial adhesion. Products can be walked on immediately. Adhesive bond reaches full strength after 24 hours.
Our Tapes & Treads have good levels of conformability and can be applied to patterned / diamond tread surfaces and stair plates. A rubber mallet should be used to help form the tape to the surface.
|Delivery||Next Day Delivery|
|Size||100mm x 18.3m (Roll)|
|Grade||Medium Profile Silicon Carbide Grit|
Assuming the stairs are smooth and dry, then anti-slip tape will OK, if the wood is sealed, perhaps varnished etc, then this would improve adhesion. Porous or dusty finished surfaces are best primed or sealed to get the best possbile adhesion. And, we'd always recommend testing a small section for suitability, before completing any project in full.
Probably not, primer is used to help seal a porous surface, so if the floor is smooth and shiny, it won't need to be primed in this situation
Our aqua tape 06-0252 is suitable for barefoot areas, the anti-slip tape is coarse and has a grit finish which isn't suitable for your suggested application