Highlight potential hazards and ensure maximum grip on stairs, steps & ramps
See below for our foil backed 'conformable treads' for use on diamond / chequer plate surfaces
Anti-Slip Tapes and Treads should be applied to clean, dry and relatively smooth surfaces. Dusty, soiled and porous surfaces should be thoroughly cleaned and prepared with anti-slip floor primer to ensure the best adhesion and ultimately product longevity. Edge sealer is also recommended for best results to prevent water / chemical ingress.
Application is best carried out when the ambient temperature is above 10oC. We recommend the use of a seam roller to apply even pressure to achieve the required 'tack' / initial adhesion. Products can be walked on immediately. Adhesive bond reaches full strength after 24 hours.
Our Tapes & Treads have good levels of conformability and can be applied to patterned / diamond tread surfaces and stair plates. A rubber mallet should be used to help form the tape to the surface.
Installation notes are for general advice only. Please contact us for specific advice about your intended application. Check out our SafetyBuyer blog for more installation tips.
|Delivery||Next Day Delivery|
|Size||150mm x 610mm (Tread)|
|Grade||Medium Profile Silicon Carbide Grit|